ESC Program Card Only for (eWatts) ESC

Product Information

With (eWatts) Program Card, you can easily set the programming value of Electronic Speed Controller (ESC) for brushless motor. Now you can just forget the complicated and boring programming method with the throttle stick.

(eWatts) Program Card has a friendly user interface and is easy to use. It is as small as a business card, so you could put it in your pocket when you are on field.

1. specification

1.1. Size: 92mm*52mm*6mm (length*width*high)

1.2. Weight: 20g

2. USER MANUAL:

2.1. FRONT PANEL:

2.1.1. Use “up/down” button to select programming item, use “left/right” button to select item value;

2.1.2. Brake: When “Brake ” is ON, the motor will stop quickly after the throttle stick is moved to bottom;

2.1.3. Low Voltage Protection Mode (Cutoff Type)：When “Soft-Cut” is selected, the ESC will reduce the output power; When “Cut-Off” is selected, the ESC will immediately cut off the output power to motor.

2.1.4. Low Voltage Protection Threshold (Cutoff Voltage)：

l For Li-xx battery (Li-ion or Li-poly)，number of battery cells are judged automatically，Low / Medium / High cutoff voltage of each cell are: 2.5V/2.75V/3.0V. For example: 3 Cell Li-Poly, when “Medium” cutoff voltage is set, the cutoff voltage is: 2.75*3=8.25V

l For Ni-xx battery (NiCad or NiMH), Low / Medium / High cutoff voltages are 60%/65%/70% of the startup voltage. For example: 6 cell NiMH battery, fully charged voltage is 1.44*6=8.64V, when low cutoff voltage is set, the cutoff voltage is : 8.64*60%=5.2V

2.1.5. Music: 4 LEDs has 16 possible states, representing 16 rhythms.


2.2. CONNETING PROCESS:

2.2.1. Disconnect the power pack from ESC;

2.2.2. Disconnect the BEC cable from receiver, then connect it to program card;

2.2.3. Connect the power pack to ESC;

2.2.4. The LEDs on program card will light, shows the current programming value of the ESC;

Remark: THE SEQUENCE OF STEP 2 AND STEP 3 IS IMPORTANT! Please connect the BEC cable to program card first, and then connect the power pack to ESC. Otherwise, the program card cannot work properly.

2.3. OPERATION:

Press “up/down” button, you can select the program item, the corresponding LED will flash. Then press “left/right” button to select the item value, the flashing LED presents the value you select. Finally, press “OK” button, the blue LED will flash, means the programming value is transmitting to ESC. When the data transmission is finished, the blue LED stop flashing and the brushless motor begin to play music, that means the news settings are accepted.

2.4. MUSIC LIST:

●= LED is lighting

Be the first to review this product!

Now In Stock !

• Ask a question about this product
• Tell a Friend
• Write review / comment